xilinx virtex 4 download cable
CASTalk.com Forum Index CASTalk.com
Discussion of DSP, FPGA, storage and embedded system.
 
 FAQFAQ   MemberlistMemberlist     RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 
Google
 
Web castalk.com
xilinx virtex 4 download cable
Goto page Previous  1, 2
 
Post new topic   Reply to topic    CASTalk.com Forum Index -> FPGA
Author Message
kurapati



Joined: 11 Apr 2005
Posts: 14
Location: Regensburg
Posted: Tue Jun 21, 2005 9:22 am    Post subject: problems in using TEMAC Reply with quote
Hi Ed,

where do I find the webserver design source of "webserver using Hard Tri-Mode Ethernet MAC . ML403".

I tried to design it myself and got strucked with clock placement constraints errors in PAR.

Hope there must be some guidelines to run webserver application similar to the one in ML403 tutorials.

Can u please give some info or hints to use TEMAC in my design to run webserver application on ML403 board.

thanks in advance
Back to top
View user's profile Send private message
opikalo1



Joined: 26 May 2006
Posts: 3
Posted: Fri May 26, 2006 3:27 pm    Post subject: Re: xilinx virtex 4 download cable Reply with quote
Ed,
I have difficulty downloading ACE file for ML403 board with gsrd design. I have ISE/EDK 7.1.02. It downloads OK, but it fails to start up. Almost like the bit file is in place, but the elf file is not. I verified genace, and it has "xcontinue" command that should start executing.
After ACE is done programing, I can connect manually through xmd, dow tx_rc.elf adn run it with no problem.

Thank you,

Oleksiy


Ed McGettigan wrote:
Good news we just updated the Gigabit System Reference Design (GSRD)
with the hard Tri-mode EMAC (TEMAC) cores and this runs on the ML403.
There is no license required to use the hard TEMAC and it will work
fine if just need 10/100 or if you just need 1 Gig.

More information can be found here:
http://www.xilinx.com/gsrd

And the updated design files can be found here:
http://www.xilinx.com/esp/wired/optical/xlnx_net/gsrd_download.htm

Ed

kurapati wrote:
Quote:
Hi Ed,

Could u please tell me how o use tri-mode-ethernet MACs embedded in
Virtex 4 FX12 for Ethernet application. Is there any reference design
available that uses only embedded MACs but not Gigabit MAC(I suppose
that needs licence and given in ML403 reference design).

Thank in advance

with regards
Rajesh
Back to top
View user's profile Send private message
 
Post new topic   Reply to topic    CASTalk.com Forum Index -> FPGA All times are GMT
Goto page Previous  1, 2
Page 2 of 2

 
 You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum




VoIP Electronics Powered by phpBB