Gabor
Guest
|
 Posted:
Thu Jan 06, 2005 6:39 pm Post subject:
Re: Refresh rate in DDR-SDRAM |
|
|
In the old days, refresh just had to be completed to all banks
in the overall refresh period, typically 64 milliseconds. With
DDR SDRAM, there is a new requirement that comes from
the use of the refresh command to enable correction in the
internal delay-locked loops. Resetting the loops only during
reset simplifies the job of reducing jitter or phase noise on
the DQS pins during memory access. The two new requirements
come from the two uses of refresh commands.
1. command interval is dictated by delay-lock loop characteristics.
This is why you can only burst 8 refreshes at a time, whereas in
older DRAM you could burst all 8K once every 64 milliseconds
and still work. From a Micron datasheet explaining the JEDEC
refresh interval requirement:
"This maximum absolute interval is to allow future support
for DLL updates internal to the DDR SDRAM to be restricted
to AUTO REFRESH cycles, without allowing excessive
drift in tAC between updates."
2. average refresh interval comes from the refresh requirement
to make sure any bank waits no longer than 64 milliseconds between
refreshes. This is the old requirement of 64 milliseconds / #banks.
Regards,
Gabor |
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in